普陀区专业滑翔伞新报价

These developments were combined in June

1978 by three friends, Jean-Claude Bétemps, André Bohn and Gérard Bosson, from

Mieussy, Haute-Savoie, France. After inspiration from an article on slope

soaring in the Parachute Manual magazine by parachutist and publisher Dan

Poynter,[7] they calculated that on a suitable slope, a "square"

ram-air parachute could be inflated by running down the slope; Bétemps launched

from Pointe du Pertuiset, Mieussy, and flew 100 m. Bohn followed him and glided

down to the football pitch in the valley 1000 metres below.[8]

"Parapente" (pente being French for "slope") was born.

From the 1980s, equipment has continued to

improve, and the number of paragliding pilots and established sites has

continued to increase. The first (unofficial) Paragliding World Championship

was held in Verbier, Switzerland, in 1987,[9] though the first officially

sanctioned FAI World Paragliding Championship was held in Kössen, Austria, in

1989.[10]

普陀区专业滑翔伞新报价

Europe has seen the greatest growth in

paragliding, with France alone registering in 2011 over 25,000 active pilots.

Wing

Cross section of a paraglider

Transverse cross section showing parts of a

paraglider:

1) upper surface

2) lower surface

3) rib

4) diagonal rib

5) upper line cascade

6) middle line cascade

7) lower line cascade

8) risers

The paraglider wing or canopy is usually

what is known in engineering as a "ram-air airfoil". Such wings

comprise two layers of fabric that are connected to internal supporting

material in such a way as to form a row of cells. By leaving most of the cells

open only at the leading edge, incoming air keeps the wing inflated, thus

maintaining its shape. When inflated, the wing's cross-section has the typical

teardrop aerofoil shape. Modern paraglider wings are made of high-performance

non-porous materials such as ripstop polyester[12] or nylon fabric.[note 1]

连云港滑翔伞便宜

Reverse launches have a number of

advantages over a forward launch. It is more straightforward to inspect the

wing and check if the lines are free as it leaves the ground. In the presence

of wind, the pilot can be tugged toward the wing, and facing the wing makes it

easier to resist this force and safer in case the pilot slips (as opposed to

being dragged backwards). However, the movement pattern is more complex than

forward launch, and the pilot has to hold the brakes in a correct way and turn

to the correct side so he does not tangle the lines. These launches are

normally attempted with a reasonable wind speed, making the ground speed

required to pressurise the wing much lower.

The launch is initiated by the hands

raising the leading edge with the As. As it rises the wing is controlled more

by centring the feet than by use of the brakes or Cs. With mid level wings (EN

C and D) the wing may try to "overshoot" the pilot as it nears the

top. This is checked with Cs or brakes. The wing becomes increasingly sensitive

to the Cs and brakes as its internal air pressure rises. 

This can be very dangerous, because now the

forces on the line have to be controlled by the moving object itself, which is

almost impossible to do, unless stretchy rope and a pressure/tension meter

(dynamometer) is used. Static line towing with stretchy rope and a load cell as

a tension meter has been used in Poland, Ukraine, Russia, and other Eastern

European countries for over twenty years (under the name Malinka) with about

the same safety record as other forms of towing.[21] One more form of towing is

hand towing. This is where 1−3 people pull a paraglider using a tow rope of up

to 500 feet. The stronger the wind, the fewer people are needed for a

successful hand tow.[22] Tows up to 300 feet have been accomplished, allowing

the pilot to get into a lift band of a nearby ridge or row of buildings and

ridge-soar in the lift the same way as with a regular foot launch.[23]

SIV是模拟d'Incident en Vol（飞行中的事件模拟）的缩写，是提供有关如何应对不稳定和潜在危险情况（例如倒塌，满是失速和开裂）的课程。这些课程通常由经过特殊培训的讲师在大片水域上讲授，通常通过无线电指导学生。将指导学生如何诱发危险情况，从而学习一旦被诱发就如何避免和补救。向希望获得更高性能和更不稳定机翼的飞行员推荐该课程，这对于大多数飞行员而言都是自然而然的进步。在某些国家，SIV课程是初步飞行员培训的基本要求。万一出现无法挽回的机动导致水着陆的情况，通常会派出一艘救援船来收集飞行员。其他增加的安全功能可能包括浮力辅助装置或辅助备用降落伞。这些课程对于新手级别的飞行不是必不可少的。

徐汇区通用滑翔伞哪家好

普陀区专业滑翔伞新报价

显示滑翔伞各部分的横截面：

1）上表面

2）下表面

3）肋骨

4）对角肋

5）上线级联

6）中线串级

7）下线级联

8）立管

滑翔伞的机翼或机盖通常在工程上称为“冲压空气翼型”。这样的翼包括两层织物，它们以形成一排网孔的方式连接到内部支撑材料上。通过使大多数舱室*在前缘处敞开，进入的空气使机翼保持充气状态，从而保持其形状。充气时，机翼的横截面具有典型的泪滴翼型形状。现代滑翔伞的机翼是由高性能的无孔材料制成的，例如尼龙纤维。

在某些现代滑翔伞（从1990年开始中，尤其是性能更高的机翼中，前缘的某些舱室被封闭以形成更干净的空气动力学轮廓。内部肋骨上的孔允许空气从开孔到这些闭孔的自由流动，以使它们膨胀，并向也闭合的翼尖膨胀。

飞行员通过悬吊线网络支撑在机翼下方。这些从两根短的（40厘米）长的坚固织带制成的立管开始。每组由一个登山扣固定在吊带上，飞行员的每一侧上各有一个，每个组的立管通常*从机翼一侧的一行上连接到绳索上。在该组的每个立管的末端，都有一个小三角洲的马龙，上面挂有数行（2 – 5）条线，形成一个风扇。这些线通常长4 – 5米，末端连接到大约2 m的另外2 – 4条线上，这些线又连接到一组更细的细线上。在某些情况下，对第四级联重复此操作。

普陀区专业滑翔伞新报价

上海翼舞航空科技有限公司致力于运动、休闲，是一家生产型公司。公司业务分为动力伞，滑翔伞，飞行，热汽球等，目前不断进行创新和服务改进，为客户提供良好的产品和服务。公司将不断增强企业重点竞争力，努力学习行业知识，遵守行业规范，植根于运动、休闲行业的发展。翼舞秉承“客户为尊、服务为荣、创意为先、技术为实”的经营理念，全力打造公司的重点竞争力。